Brooks Brothers 2010 bow blouse

We’ve had a few inquiries about the bow blouse and the bow that’s been such a favorite here at the organization. Not only does it hark back to the classic days of the housewife, it’s actually being revived this year by designers like Louis Vuitton for their Fall ’10 collection.

The bow of yesteryear had pointed ends, as opposed to the more modern squared tips. It’s virtually impossible to come across these, unless one goes to the “Vintage” section in Ebay, dig through Goodwill, or find an old pattern. Carolyn says it’s a snap to make your own, and she’s been gracious enough to show us how. Here it is:

Step 1. Measure
Take a clean silk or cloth ribbon (ones for gift-wrapping and crafts) and wrap it around your neck to tie a bow, making sure the ends are to your liking. Trim the ends (the shape of the ends doesn’t matter, we just want the length) and measure the length.

Step 2. Make a Construction Board (or Cardboard) Template
On a construction board-Poster board, trace a shape of bow you want as it would look, lain out on a flat surface. ADD 1/8 – 1/4 inch on the two short and one long side. The side on the fold – (i.e. the dotted A line – does not need a seam) This is for the seam allowance, depending on the material) Now, Draw that shape side-by-side on the cardboard and cut the cardboard.

Approximate pattern of the bow laid flat, side by side, since you want to fold the cloth together along dotted line A

Step 3. Lay your cloth over the cardboard template, trace onto cloth and cut.

Step 4. Fold the cloth
With the right (outside) sides together- over line A, making the mirrored shape come together into one single shape, wrong side facing out. A few steps later, you will be stitching the cloth together before pulling it inside out to hide the seams.

Step 5. Sew two pull strings, one at each “tip” of the bow.

Sew two pull strings, one at each tip of the bow, connecting both sides of the fabric. Then feed the pull string to stick out the center of the folded cloth. (You will be pulling the tips to invert to the proper side up after you sew the seams)

Step 6. Making sure the two drawstrings are accessible, and sandwiched freely inside the two sides of fabric, sew from point A to point F, leaving a opening in the middle of the long edge.

Sew 1/8 to 1/4 inch from the edge of the fabric, enclosing the short edge, the long edge, and to the end of the other short edge. This would effectively seal the fold from one end to another, With the exception of the opening.

Very important: Make sure the opening is big enough to pull an amount of fabric for half the bow from inside out. You will be using the drawstrings to bring each half of the bow out through the opening.

Step 7. Use the drawstrings and gently pull out the tips of the bow, bringing the correct side of the cloth out through the opening.

Step 8. Once tips and completely pulled through and the bow is correct fabric side facing outwars, flatten the whole piece to correct shape. Cut the drawstring at the tips, and slipstitch the opening.

Voila! Stepford Bow!